Mr. Heater MH80CV Instructions d'exploitation télécharger pdf (Page 6)

Mr. Heater |Convection Construction Heater Operating Instructions and Owner’s Manual

OPERATING INSTRUCTIONS

PREPARING FOR OPERATION

1. Extend the shell fully and lock into place as shown in the

enclosed instructions sheet before lighting or operating the

heater.

2. Check the heater for possible shipping damage. If any is

found, immediately notify the factory.

3. Follow all of the Safety and Operating Precautions.

4. Connect the POL fitting of hose and regulator assembly to

the propane cylinder by rotating the POL nut

counterclockwise into the propane cylinder's valve outlet

and securely tighten with a wrench.

5. Connect the hose to the heater.

6. Securely tighten all gas connections.

7. Open the cylinder's gas valve and check all gas connections

with a soap and water solution. DO NOT USE A FLAME.

START

1. WARNING: BEFORE LIGHTING PILOT, fully close the ball

valve (turn knob fully clockwise).

2. Fully open the valve on the propane cylinder and wait 15

seconds before Step 3.

3. Depress red button on safety pilot valve admitting gas to

the heater. Then push and release the ignition button until

the pilot lights.

4. When the pilot lights, continue to hold the button

depressed for 30 seconds, then release.

5. If pilot goes out, wait 5 minutes and repeat the lighting

procedure.

6. When the pilot remains lit, open the ball valve (turn knob

counter clockwise) to light main burner. Partially close valve

to regulate heat output.

STOP

1. Securely close valve on the propane cylinder.

2. Continue to operate heater until all fuel in the hose has

burned.

3. Fully close the ball valve.

RESTART AFTER SAFETY SHUTDOWN

1. Securely close valve at propane cylinder.

2. Wait 5 minutes.

3. Restart following "Start" procedure.

SERVICING

A hazardous condition may result if a heater is used that has

been modified or is not functioning properly. When the heater is

working properly:

* The flame is contained within the heater.

* The flame is essentially blue with perhaps some yellow tipping.

* There is no strong disagreeable odor, eye burning or other

physical discomfort.

* There is no smoke or soot internal or external to the heater.

* There are no unplanned or unexplained shut downs of the

heater.

The parts lists and exploded view show the heater as it was

constructed. Do not use a heater which is different from that

shown. In this regard, use only the hose, regulator and cylinder

connection fitting (called a POL fitting) supplied with the heater.

IMPORTANT Match the color stripe on the hangtag attached to

the hose assembly with the color on the label located near the

propane inlet fitting on the heater. Do not use alternates. For

this heater, the regulator must be set as shown in

"specifications". If there is any uncertainty about the regulator

setting, have it checked.

A heater which is not working right must be repaired, but only

by a trained, experienced service person.

In-warranty products will be repaired with no charge for either

parts or labor. Please include a brief statement indicating date,

place of purchase, the nature of the problem and proof of

purchase.

Out-of-warranty products will be repaired with a charge for parts

and labor.

MAINTENANCE AND STORAGE

1. The heater should be inspected before each use, and at

least annually by a qualified person.

2. Before each use, check the soft "O" ring seat at the bullnose

of the POL fitting. If the "O" ring is cut, scuffed, or

otherwise damaged, replace it with part number 6681.

3. Turn off the gas at the LP-gas supply cylinder(s) when the

heater is not in use.

4. When the heater is to be stored indoors, the connection

between the LP-gas supply cylinder(s) and the heater must

be disconnected and the cylinder(s) removed from the

heater and stored out of doors and in accordance with

Chapter 5 of the standard for Storage and Handling of

Liquefied Petroleum Gases ANSI/NFPA 58 and CSA

B149.1,Natural Gas and Propane Installation Code.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Mr. Heater MH80CV Instructions d'exploitation Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffages d'appoint Mr. Heater MH80CV